- Usb network gate user guide serial#
- Usb network gate user guide pro#
- Usb network gate user guide plus#
- Usb network gate user guide windows#
Optimize also creates mute control routes in rooms with MXA network mute buttons. Note: The input and output LEDs stay off when metering is set to Post-gain and the channel is muted.ĭesigner's Optimize workflow speeds up the process of connecting systems with at least 1 microphone and 1 audio processor. Tri-color LEDs indicate the audio signal level for the analog channels. Note: Error details are available in the Event Log. Problem detected with connected USB audio device
Usb network gate user guide plus#
Power: Power over Ethernet Plus (PoE+) present Resets the device settings back to the factory default. Use the matrix mixer to sum any combination of signals from the P300 into a single mono channel and send through the USB output.Ĭonnects to a network switch to connect Dante audio, Power over Ethernet (PoE), and data from the control software. Set the output level to match the input sensitivity of the analog device (Line, Aux, or Mic level).Ĭonnects to a computer to send and receive audio signals. Provides an optional connection for microphone shield wire to chassis ground.īalanced audio output connects to an analog device. Set the analog input level to match the output level of the analog device. Note: Left and Right audio signals are summed to a mono signal.īalanced audio input connects to an analog audio device.
Note: See the cable requirements for additional information. Supports bidirectional audio with a TRRS cable, or sends audio into the P300 with a TRS cable. If in doubt please raise a support request at the link given above to request up-to-date information, especially if you want to use a different version of Citrix.TRRS mobile input connects to a mobile device.
Usb network gate user guide serial#
If using any of our older pads please raise a Support Ticket.įor older versions of Citrix (of which the most common is probably 6.5) then you would need to use the 430V or the STU 540 in serial mode.Īt the time of writing the maximum supported baud rate for these devices on XenDeskTop or XenApp 6.5 is 128,000 bits per second. Similar information can be seen on Citrix's own Web site here: Citrix Compatible Wacom Pen Devices
Native support for Wacom signature pads was introduced with Citrix 7.6.3 (Feature Pack 3) as documented at this What's New article.Īt the time of writing (July 2019) the list of currently supported devices is here: Citrix supported devices We do not have any performance measurements for the above tools nor do we provide support for them - you would need to contact the suppliers themselves and test them. Please note that although we have had some success with these in certain configurations we cannot guarantee that they will work in your particular environment.
Usb network gate user guide pro#
Use an additional product to forward the pen data to the server (USB redirection). Please see however the special note on Citrix below. The STU 430V and 540 in serial mode can be used with both our SDKs - STU and Signature - subject to appropriate coding.
Instructions for setting up the 430V are provided on the STU serial connection guide.įor the 430V please see also STU-430V Installation and Configuration.įor the 540 please see also Configuring the STU-540 for serial operation
Usb network gate user guide windows#
When STU pads operate as serial devices they are not subject to the same restrictions which Windows applies to STUs operating as standard USB devices. Use the monochrome STU-430V serial device or colour STU-540 pad (which can be configured to operate serially). There are currently two options for making STU tablets work in a remote desktop, thin client or Citrix environment: 1. Use Remote Desktop and Citrix for signature capture
0 kommentar(er)
